Draytek Vigor2830N User Manual

Vigor2830n V2 Quick Start Guide
2
1
1
.
.
1
1
P
P
a
a
n
n
e
e
l
l
E
E
x
x
p
p
l
l
a
a
n
n
a
a
t
t
i
i
o
o
n
n
LED Status Explanation
Blinking The router is powered on and running normally.ACT
(Activity)
Off The router is powered off.
On USB device is connected and ready for use. USB
Blinking The data is transmitting.
CSM On The profile(s) of CSM (Content Security
Management) for IM/P2P, URL/Web Content
Filter application can be enabled from Firewall
>>General Setup. (Such profile must be
established under CSM menu).
On
Wireless access point is ready.
WLAN
Blinking
It will blink slowly while wireless traffic goes
through.
ACT and WLAN LEDs blink quickly and
simultaneously when WPS is working, and will
return to normal condition after two minutes.
(You need to setup WPS within 2 minutes.)
On The router is ready to access Internet through
DSL link.
DSL
Blinking Slowly: The DSL connection is ready.
Quickly: The connection is training.
On The WAN2 connection is ready. WAN2
Blinking It will blink while transmitting data.
On The DoS/DDoS function is active. DoS
Blinking It will blink while detecting an attack.
VPN On The VPN tunnel is active.
QoS
On The QoS function is active.
LED on Connector
On The port is connected.
Off The port is disconnected.
Left LED
(Green)
Blinking The data is transmitting.
GigaLAN
1/2/3/4
Right LED
(Green)
On The port is connected with
1000Mbps.

Draytek Vigor2830N Specifications

General

Brand	Draytek
Model	Vigor2830N
Category	Firewall
Language	English