1
Packing List:
Before you start installing VigorSwitch G2080, please verify that the package
contains the following items:
VigorSwitch G2080
Power Cord
CD
Console Cable
Rubber feet
Rack mount kit
Please notify your sales representative immediately if any of the items is missing or
damaged.
Power Requirements: AC Line
Voltage
: 100∼240 VAC
Frequency
: 50∼60 Hz
Consumption : 13W
Quick Installation:
1. Install the switch in the rack with mounting accessory.
2. Connect the switch to an AC power source.
3. The port 1–8 connector is RJ-45 jack on the switch. Use Category 5 UTP
cable to connect between the switch and end station.
4. The port 7, 8 includes two types of media --- TP and SFP fiber modules; they
support TP or fiber with auto-detected function.
5. Use RS-232 interface to pre-configure the switch for network management.
6. For example: IP address, VLAN, Port Trunking, STP, etc.
The default settings for switch’s serial port are listed as follows:
Baud rate 57600
Stop bits 1
Data bits 8
Parity N
Flow control none
The default values of the switch are listed as follows:
IP Address/Subnet Mask/Default Gateway: Assigned by DHCP Server
Username : admin
Password : admin
User also can use telnet or web to pre-configure the switch with the default IP
address and username/password in the first configuration.
To Next Page
Need help?
General
