18
EN
Problem Type
Does leaving the robot
on the charging dock
consume power if it is
already fully charged?
No water comes out of
the mopping module, or
only a little bit comes out
Robot doesn’t resume
cleaning after charging
Robot doesn’t return to
charging dock after being
moved
Solution
Leaving the robot on the charging dock after it’s fully charged consumes very little
electricity and helps maintain optimal battery performance.
Conrm that the water tank is lled with water, and clean the mop pad if necessary.
Clean the mop if it becomes dirty.
Make sure the mop pad is installed correctly according to the user manual.
Clean the blowhole on the top of the water tank.
Moving the robot may cause it to re-position itself or re-map its surroundings. If the
robot is too far from the charging dock, it might not be able to automatically return
on its own, in which case you need to manually place the robot onto the charging
dock.
Make sure the robot is not set to Do Not Disturb Mode, which will prevent it from
resuming cleaning.
The robot does not resume cleaning when it is manually recharged or placed onto the
charging dock.
FAQ
Robot does not perform
scheduled cleaning
The robot has low battery. Scheduled cleaning will not start unless the robot has been
recharged in time.
To Next Page
Loading...
Need help?
General
