7
EN
Location Requirements
Installation Precautions
·If the size of the 3-way diverter valve does not match, please purchase a
suitable adapter separately.
·Use a water pressure gauge to measure the water pressure and confirm
that it is between 0.14 MPa and 1 MPa.
·Close the main water valve in your home before installation and make sure
all the water in the pipes has been drained.
·Do not connect the water hookup kit to a hot water source.
·Before installation, please unplug the base station and make sure the base
station is not connected to the power supply.
·Installation location needs to avoid direct sunlight and water.
·The location is recommended to be close to the water source and floor
drain.
·It is recommended that the distance between the base station and the
socket be within 1.5 m.
·Leave enough space as shown in the figure and remove any objects in the
shaded area.
·Place the base station in a location with a good 2.4 GHz Wi-Fi signal.
Installation Instruction
＞1m
To Next Page
Loading...
