Dreame RLS6LADC-6 - Before Use; Initial Setup: Preparation and Installation

9
EN
Note: Install the side brush until it clicks into place.
1. Remove the protective strips 3. Connect to an Electrical Outlet
PlacethebasestationinalocationthatisasopenaspossiblewithagoodWi-Fi
signal.Insertthepowercordintothebasestationandplugitintothesocket.
4. Place the Base Station
Removeanyobjectsthatarecloserthan1.5mfromthefront,1mfromthetop,
and0.5mfromeithersideofthebasestation.
2. Install the Side Brush and the Mop Assembly
Before Use
Note:
·
Make sure that no objects might block the signaling area.
·
To prevent water stains from wetting wood floors or carpets, placing the base
station on tile floors or marble floors is recommended.
Firmly insert the power
cord upwards until the
indicator turns on.
Side Brush Clip
> 0.5 m
> 0.5 m
> 1 m
> 1.5 m
I：ON
O：OFF