10
EN
- MAX -
5. Place the Robot
Press and hold the button on the robot for 3 seconds to turn it on. Place
the robot onto the base station with the mop assembly facing toward
the washboard. Then you will hear a voice notication when the robot
successfully connects to the base station and starts charging. After the robot
is fully charged, the status indicators on the robot and the base station will
remain lit for 10 minutes and will then dim.
6. Add Water to the Clean Water Tank
Take out the clean water tank from the base station, and ll it with clean
water up to the max water line. Then install it back into the base station.
Before Use
Note: It is recommended to fully charge the robot before its rst use. When the
robot cannot be turned on after the battery is depleted, manually connect the
robot with the station to charge it.
MAX Water Line
Note:
·
Do not add hot water to the water tank, as this may cause the tank to become
deformed.
·
Do not add any liquid other than the officially-approved cleaner to help prevent
base station malfunction.
To Next Page
Loading...
