Dreame RLS6LADC-6 - Connecting with Dreamehome App; App Connectivity: Download and Installation; App Connectivity: Device Setup and Wi-Fi

11
EN
Wi-Fi Indicator
·
Blinking slowly: To be
connected
·
Blinking quickly: Connecting
·
On: Connected
Open the Dreamehome App, tap " " in the upper right corner, and scan
the QR code above again to add "DreameBot L10 Ultra". Please follow the
prompts to nish the Wi-Fi connection.
This product works with the Dreamehome App, which can be used to
control your device.
Connecting with Dreamehome App
1. Download the Dreamehome App
Scan the QR code on the robot, or search " Dreamehome" in the app store to
download and install the app.
2.Add Device
Note:
• Only 2.4GHz Wi-Fi is supported.
• Due to upgrades in the app software, the actual operations may be dierent
from the statements in this manual. Please follow the instructions based on the
current app version.
3. Reset Wi-Fi
Simultaneously press and hold the buttons and until you hear a voice
prompt saying, “Waiting for the network conguration.” Once the Wi-Fi
indicator is blinking slowly, the Wi-Fi has been successfully reset.
Note: If your robot cannot connect to the app successfully, reset the Wi-Fi and add
the device again.
Scan QR code on the device
Add Device
My Devices
Scan QR code to connect.