Use a tool such as a small screwdriver to separate the axle and tire of the omnidirectional wheel. Do not use
excessive force.
Rinse the omnidirectional wheel under the running water and put it back after drying it completely.
Dust Box
1. Open the robot’s cover and press the clip to remove the dust box.
2. Open the dust box cover and empty the dust box as shown in the diagram.
Filter
1. Remove the filter and tap its basket gently.
Note: Do not attempt to clean the filter with a brush, a finger or sharp objects to prevent damage.
2. Rinse the dust box and filter with water and dry them completely before reinstalling.
Note:
Rinse the dust box and filter with clean water only. Do not use any detergent.
Use the dust box and filter only when they are completely dry.
To Next Page
Loading...
