To Next PageTo Next Page
Need help?Do you have a question about the Dreamline ALLIANCE PRO BG SDAB60A700 and is the answer not in the manual?
Warning regarding potential shattering of tempered glass due to improper installation, handling, or misuse.
Instructions for unpacking, checking parts, verifying wall and threshold conditions, and protecting surfaces.
Crucial safety warnings about handling glass, using safety equipment, and proper installation practices.
Information on door reversibility and critical precautions for handling door glass to prevent damage or injury.
Locate and mark center lines on threshold and walls. Center the bottoms of Wall Profiles on the center line.
Level Wall Profiles, mark holes, drill and insert Wall Anchors. Drill pilot holes for studs if present.
Apply silicone to Wall Profiles, install with screws. Install Bottom and upper Bumpers using specific screws.
Measure distance between Wall Profiles and cut Bottom Profile to size. Remove burrs after cutting.
Measure distance between walls and cut Guide Rail to size. Remove burrs after cutting. Secure with screws.
Install Roller Wheels at the center of door glass slots. Secure them using Wheel Bolts.
Place Inside Door Glass first, then Outside Door Glass in the shower opening. Protect glass edges.
Install the Outside Door Glass from outside. Face Roller Wheels outward and lift into the Guide Rail.
From inside, lift the Inside Door Glass into the Guide Rail with Roller Wheels inward. Slide doors to one side.
Adjust Roller Wheels to align door glass edges with wall profiles for leak prevention.
Place Center Guide on Bottom Profile, snap it down, and move to the center beneath door glass. Secure with screw.
Install Pull Handle on Inside Door Glass. Install Towel Bar Bracket on Outside Door Glass and secure to Towel Bar.
Install Towel Bar Bracket on the opposite side of the Outside Door Glass at the same height as the other bracket.
Move doors to side. Apply silicone to Anti-Jump Inserts and snap into position at the end of the Top Guide Rail.
Apply silicone to the interior perimeter of the shower door. Allow 24 hours for curing before use.
Wipe acrylic back walls after each use with a soft cloth. Use non-abrasive sprays or cream cleaners.
Wipe glass with a soft cloth after each use. Rinse and wipe to prevent buildup and water spots.
Wipe all metal parts with a soft cloth. Avoid abrasive cleaners. Rinse and dry after cleaning.
Inspect unit stability, screws, door operation, glass edges, and silicone for maintenance.
General| Product Type | Shower Door |
|---|---|
| Series | ALLIANCE PRO |
| Model Number | SDAB60A700 |
| Type | Bypass |
| Shape | Rectangular |
| Frame Type | Framed |
| Frame Material | Aluminum |
| Glass Type | Clear |
| Glass Thickness | 5/16 inch |
| Door Type | Sliding |
| Opening Width | 56-60 inches |
