DREAMS Yardley Double Ottoman

To Next Page

Yardley Double Ottoman

Assembly Instructions

Need assistance?

Call: 0344 292 0000

Dimensions mm Length Width Height

Double

2040 1480 910

Approximate time to

assemble this product

Retain these instructions

for future reference

2 x people recommended to

assemble this product

Do not discard any of the

packaging until you have

checked that you have all the

parts and the pack of ﬁxings.

You will require a cross

head screwdriver

Helpful advise before you begin:

1. We suggest you spend a short time reading through this leaﬂet

and then follow the simple step by step instructions.

2. If you follow the instructions carefully the end result should be

worth the effort.

3. Do not discard any of the packaging until you have checked that

you have all the parts and the pack of ﬁttings.

4. Assemble this product on a carpet.

5. To ensure an easier assembly, we strongly advise that all ﬁttings

are only ﬁnger tightened during initial assembly. Only upon

completion of the assembly should all ﬁxing points be fully

tightened.

6. We recommend a periodic check on all ﬁxing points to make

sure they remain fully tightened.

7. Keep glue and ﬁttings out of children’s reach.

8. Do not use any other tools other than those recommended to

build this product.

9. Please do not use substitute parts. Use only additional or

replacement parts supplied by Dreams Ltd.

10. In the unlikely event that this product has missing or damaged

parts, please call 0344 292 0000 to obtain spares.

Page 1 of 8

1/2

Main Page

Need help?

Do you have a question about the DREAMS Yardley Double Ottoman and is the answer not in the manual?

Summary

Assembly Introduction and Guidance

Helpful Advice Before Assembly

Key recommendations and preparation steps for a smooth assembly process, including reading instructions and checking parts.

Product Specifications and Support

Details the bed dimensions and provides contact information for customer assistance.

Parts and Fittings Checklist

Component Parts Identification

Lists and illustrates all the main physical components required for the bed frame assembly.

Hardware and Fixings List

Details all nuts, bolts, screws, washers, and tools needed for construction.

Bed Frame Assembly - Core Structure

Attaching Headboard and Footboard Rails

Secures side rails to headboard and footboard using bolts, ensuring correct alignment before tightening.

Securing Corner Brackets and Mats

Attaches corner brackets and soft mats to the frame for structural integrity and stability.

Bed Frame Assembly - Base and Feet

Attaching the Fabric Base

Secures the fabric base material to the bottom of the assembled bed frame.

Fitting the Bed Feet

Attaches the feet to the underside of the headboard and footboard using screws.

Bed Frame Assembly - Slat System

Positioning the Slat Frame

Places the upper slat frame assembly onto the main bed base structure.

Securing the Slat Frame

Fastens the slat frame to the bed structure using bolts, nuts, and washers for stability.

Bed Frame Assembly - Lift Mechanism

Attaching Support Legs

Installs the support legs onto the slat frame for additional structural support.

Connecting Slat Frame to Lift Pistons

Loosely secures the slat frame to the lift mechanism using bolts, washers, and nuts.

Bed Frame Assembly - Final Steps

Securing Lift Mechanism Pistons

Firmly attaches the gas lift pistons to the frame using locking nuts, ensuring correct movement.

Attaching the Handle Strap

Connects the handle strap to the frame, essential for operating the ottoman lift mechanism.

Furniture Care and Maintenance

Delivery and Initial Setup Advice

Guidance on airing the bed after delivery and considerations for placement on different surfaces.

Daily Cleaning and Long-Term Checks

Instructions for cleaning the furniture and periodic checks for loose fittings after six months.

Return Policy Information

Details the procedure and conditions for returning damaged or faulty furniture items.