Dremel 100 - Page 27

27
Speed Settings (Continued)
Not all speed settings can be achieved on 100 and 200 series tool. For certain applications,
a variable speed tool is required.
Speed Settings: 2 (5,000 - 8,000 RPM) 4 (9,000 - 15,000 RPM) 6 (16,000 - 21,000 RPM)
8 (22,000 - 27,000 RPM) 10 (28,000 - 35,000 RPM)
* Speed for light cuts, Caution - burning on deep grooves.
• Depending on cutting direction relative to grain.
Flapwheels
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
502, 503, 504, 505 10 8 2 10 8-10 - - -
Finishing Abrasive Buffs
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
511E, 512E 4 4 4 4 4 - - -
Detail Abrasive Brushes
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
EZ471SA,
EZ472SA,
EZ473SA
2-6 2-6 2-4 2-6 2-6 - - -
Drill Bit
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
150 10 8-10 2-4 - 6 - - -
Glass Drilling Bits
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
662DR, 663DR - - - - - 4-6 4-6 4-6
Grout Removal Bits
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
569, 570 For use on wall and floor grout - 6-8 -
1600A011JA 11-21 100 200 3000.qxp_100 200 3000 11/22/21 1:07 PM Page 27