Dremel 100 - Page 26

26
Speed Settings (Continued)
Not all speed settings can be achieved on 100 and 200 series tool. For certain applications,
a variable speed tool is required.
Speed Settings: 2 (5,000 - 8,000 RPM) 4 (9,000 - 15,000 RPM) 6 (16,000 - 21,000 RPM)
8 (22,000 - 27,000 RPM) 10 (28,000 - 35,000 RPM)
* Speed for light cuts, Caution - burning on deep grooves.
• Depending on cutting direction relative to grain.
Chain Saw Sharpening Stones
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
453, 454, 455 - - - 10 - - - -
Cutting Accessories
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
409, 420, 426, 540,
EZ409
- - 2-4 10 10 10 10 -
543, EZ544 10 8-10 2-4 - - - - -
545, EZ545 8-10 8 - - - 6-8 6-8 -
560
For use on drywall. For best results, use at 10
561 6-10 6-10 2-4 - 10 - - -
562 - - - - - - 10 -
EZ456 - - - 10 10 - - -
EZ476 - - 2-4 - - - - -
Polishing Accessories
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
461, 462, 463 - - - 8 8 8 8 8
414, 422, 429 - - - 6 6 6 6 6
425, 427 - - - 8 8 - - -
423E - - - 6-8 2 2 2 6-8
Wire Brushes
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
403, 404, 405 4 4 2-4 6 2 - - -
428, 442, 443 4 4 2 4 4 - - -
530, 531, 532 - 4 - 4 - - - -
535, 536, 537 4 4 - 4 4 4 - -
Sanding Bands and Discs
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
407, 408, 430, 431,
432, 438, 439, 440,
444
2-10 2-10 2-6 10 10 2-10 2-10 -
411, 412, 413 6 6 2 - 2 - - -
1600A011JA 11-21 100 200 3000.qxp_100 200 3000 11/22/21 1:07 PM Page 26