Dremel 100 - Speed Settings

24
Not all speed settings can be achieved on 100 and 200 series tool. For certain applications,
a variable speed tool is required.
Speed Settings: 2 (5,000 - 8,000 RPM) 4 (9,000 - 15,000 RPM) 6 (16,000 - 21,000 RPM)
8 (22,000 - 27,000 RPM) 10 (28,000 - 35,000 RPM)
* Speed for light cuts, Caution - burning on deep grooves.
• Depending on cutting direction relative to grain.
Speed Settings
High Speed Cutters
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
100, 121, 131 10 10 6 6 8 - - -
114,124, 134, 144 10 6 4 6 6 - - -
118, 190, 191, 192,
193, 194
10 10 4 6 10 - - -
116, 117, 125, 196 10 6 4 6 6 - - -
115 10 10 4 6 6 - - -
198, 199 10 8 4 6 6 - - -
Engraving Cutters
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
105, 108 10 10 8 4 6 - - -
106, 107, 109, 110 10 10 6 4 6 - - -
111 10* 10* 8* 4 6 - - -
112, 113 10* 10* 6* 4 6 - - -
Diamond Wheel Points
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
7103, 7105, 7117,
7120, 7122, 7123,
7134, 7144
10 8 - - - 10 10 10
Structured Tooth Tungsten Carbide Cutters
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
9931, 9932, 9933,
9934, 9935, 9936
10 8 4 - 6 - - -
1600A011JA 11-21 100 200 3000.qxp_100 200 3000 11/22/21 1:07 PM Page 24