Dremel 8300 - Page 20

-20-
224BB>AH
""
Base plate for
sanding
""
3/8 " HCS wood
flush cut blade
""
3/4
" HCS wood
flush cut blade
""
3/4
" BIM wood
metal flush cut
blade
""
3
" HCS Flat
Saw Blade
""""
Segmented
1/8", 1/16" grout
removal
""
Rigid scraper
blade
""
Flexible scraper
blade
""
60 grit diamond
paper
""%
Sand paper
"",
Sand paper
"0C4A80;
Depends on sanding
sheet
Wood, plastic,
drywall and other
soft materials
Wood, plastic
drywall and other
soft materials
Non-ferrous metals,
wood, plastic and
other soft metals
Wood (limited use on
hard wood) plastic,
drywall and other
soft materials.
Grout joints
Vinyl, varnish and
carpeting
Caulk, adhesives,
paint and other soft
materials
Thinset, cement
motar and paint.
Varnish and paint
removal
Bare wood,
hardwood, softwood,
chipboard, metal
??;820C8>=
Sanding surfaces close to edges, in
corners or hard to reach areas.
Depending on the sanding sheet for, e.g.,
sanding wood, paint, varnish, thinset
and cement.
Smaller cuts and flush cuts. Example:
Cut-outs in furniture for cable
connections.
Cutting and deep flush cuts; also for
sawing close to edges, in corners and
hard to reach areas.
Example: Flush cutting door jamb or
window sill, for flooring or tile installation.
Smaller cuts and plunge cuts.
Example: Sawing off water pipes
(copper) or cable ducts flush against
walls, floors or ceilings.
Cutting in existing trim or flooring. Cutting
close to edges in corners or hard to reach
areas. Examples: Installing floor vent or
repairing damaged wood flooring.
Removing grout from between wall or
floor tiles.
Example: Removing grout joints between
wall tiles for repair work.
Remove vinyl flooring and bonded
carpeting. Example: On stairs/steps or
other small/medium sized surfaces.
Scraping off old coats of varnish/paint or
other adhesive.
Removing caulk, coats of peeling paint
or soft adhesive.
Removing thinset or cement; Example:
Grinding away thinset after tile removal.
Removing paint or oil stains from cement.
For sanding primer and removing brush
strokes, drops of paint and paint run.
For detail sanding.
"D;C8"0G224BB>A84B
(8670A1>=(C44;8"8"4C0;
DM 2610011834 07-10:DM 2610011834 07-10.qxp 7/20/10 1:20 PM Page 20