dreo Atom 316 - Troubleshooting; LED Display Malfunctions; Heater Fails to Start

TROUBLESHOOTING
Troubleshooting
e SR m
Unplug it from the power
source and contact
Customer Support.
E2- Temperature
sensor short circuit
B Unplug it from the power
&l Temperatqre " source and contact
sensor open circuit B s
Malfunction
codes on LED
display
Unplug
and
wait
for
it
EhnOveicsy to cool down before
Protection plugging in again.
) Place the heater back on
B over a flat, level and stable
(et surface.
Power cord is not. Connect the plug to
i a powered electrical
properly pluggedin. 3 POWS
Heater does :
Unplug and allow it to
not start o
Overheat protection
has been activated.
Remove any objects on
or near the heater.
11 reo PTC AN HEATER