07-02282A F571-230V & F571-110V 8 Legend Brands Europe Holdings Ltd.
TROUBLESHOOTING
Water drips out
when moving unit
Unit was unplugged before
purging was complete.
Purge unit before moving. See “At the End of the Job,” p. 5.
Unit not switched on.
No power to machine.
Switch unit on.
Plug in unit; check power cord connection at wall outlet.
Unit operating, but
room not dry
Not enough time to dry.
Poor air movement in room.
Excessive moist air infiltration.
Allow more time for drying.
Increase air movement with air movers.
Seal off area to reduce infiltration.
Unit collects too
little water
Room air is dry.
Room temperature is too low.
Filter is clogged.
Coils are clogged.
Confirm humidity level with hygrometer.
Increase room temperature.
Check filter. Clean or replace as necessary.
Check coils. Clean as necessary.
If the problem you are experiencing is not listed here, call your local distributor for assistance.
SPECIFICATIONS
Cube Dehumidifier
Model F571-230V
Cube Dehumidifier
Model F571-110V
Water removal
27°C/60% RH
Water removal
30°C/80% RH
Water removal
20°C/60% RH
Weight (w/ cord and
hose)
Power (compressor
rating)
Operating
temperature range
Specifications are subject to change without notice. Some values
may be approximate.
PARTS INCLUDED
6 m drain hose with quick-connect fitting.
7.6 m power cord.
Mesh air filter
FILTER REORDERS
F577 Mesh air filter (pack of 6)
ADDITIONAL PRODUCT INFORMATION and current
documentation is available at
www.legendbrandseurope.com
FOR PARTS AND SERVICE contact your local
distributor.