• Remove the chrome rims "A" by turning
Contrary to the clock hand.
• Change type GU10-2W-12VScrewing it.
• Reassemble them by performing the operation
in the reverse order.
5. INSTALATION
GENERAL BUSINESS
• If you have an outlet to the outside:
Your extractor can be connected to it by
means of an extraction duct (enamel,
aluminum, flexible pipe or non-flammable
material with an inner diameter of 150 mm)
(supplied with the extractor).
• If you do not have an outlet to the
outside:
All our appliances have the option to operate
in re-circulation (with no outlet to the
outside).
Under these circumstances, add a charcoal filter activator, which will catch odors
(See instructions on page 7).
This filter is available through your dealer under the reference number indicated on
the nameplate. (See inside the extractor)
MOUNTING
• Pre-assembly recommendations:
The extractor must be 70cm from the burners so that it is properly adjusted.
Draw a vertical line on the wall to center the extractor (and fireplace) properly on
the stove.
Make a mark on the vertical line 70 cm above the surface of the burner. This
vertical line at 70cm will help you correctly position the supplied mounting pattern.
To Next Page
Loading...