Drill Master 93816 - Page 8

SKU 93816 For technical questions, please call 1-800-444-3353. Page 8
4. When using more than one extension cord to make up the total length, make sure
each cord contains at least the minimum wire size required. (See Figure C.)
5. If you are using one extension cord for more than one tool, add the nameplate am-
peres and use the sum to determine the required minimum cord size.
(See Figure C.)
6. If you are using an extension cord outdoors, make sure it is marked with the suffix
“W-A” (“W” in Canada) to indicate it is acceptable for outdoor use.
7. Make sure your extension cord is properly wired and in good electrical condition.
Always replace a damaged extension cord or have it repaired by a qualified electri-
cian before using it.
8. Protect your extension cords from sharp objects, excessive heat, and damp or wet
areas.
*SDROCNOISNETXEROFEGUAGERIWMUMINIMDEDNEMMOCER
ETALPEMAN
SEREPMA
)daoLlluFtA(
HTGNELDROCNOISNETXE
teeF52teeF
05teeF57teeF001teeF051
0.2-08181818161
4.3-1.28181816141
0.5-5.38181614121
0.7-1.58161412121
0.21-1.781412101-
0.61-1.21412101--
0.02-1.612101 ---
CERUGIF
evifotpordegatlovenilehtgnitimilnodesaB*
.serepmadetarehtfo%051tastlov
Symbology