DriSteem VAPORMIST Installation Instructions And Maintenance Operations Manual

22 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

READ AND SAVE THESE INSTRUCTIONS

VAPORMIST and

VAPORMIST DI

ELECTRIC STEAM HUMIDIFIERS

For Ducted or Ductless Applications

Installation Instructions

and

Maintenance Operations

Manual

ä

®

®

UL LISTED

CUL LISTED

VM-IOM-1996 Scan.pdf 1 11/19/2009 9:57:17 AM

Table of Contents

Other manuals for DriSteem VAPORMIST

Installation, Operation And Maintenance Manual56 pages

Service Kit Manual18 pages

Questions and Answers:

V
valerienashAug 13, 2025
Why is my DriSteem Humidifier not heating?
- J
  Jackie BoothAug 13, 2025
  If your DriSteem Humidifier isn't heating, it could be due to several reasons. First, check the main line safety switch and fuses, and ensure the unit is receiving the correct supply voltage. Another possible cause is an incorrect or nonexistent control voltage. In this case, try resetting the control transformer circuit breaker and verify that there's 24 VAC control circuit voltage at T-1 and T-2 on the control board. Also, make sure the humidistat is calling for humidity and that it isn't faulty. Finally, check the safety controls, air flow switch, and high humidistat.
T
Tanya DavisAug 17, 2025
What to do if my DriSteem VAPORMIST Humidifier will not fill?
- A
  Amanda KnightAug 17, 2025
  If your DriSteem Humidifier isn't filling, start by checking the water supply and shut-off valves to ensure there's water pressure at the valve. Then, check the water fill valve to see if it's receiving 24 volts. Also, inspect the strainer and valve for any blockages. Finally, verify the control voltage across the fill valve output, as a faulty control board could be the reason.
H
Heather JonesAug 20, 2025
Why does my DriSteem VAPORMIST have low output even with proper water level?
- W
  wthorntonAug 20, 2025
  If your DriSteem Humidifier has reduced or no output despite the water being at the correct level, it could be due to a malfunctioning heater. Verify that the proper voltage is being applied to the heaters and check the heater amp draw, comparing it to the wiring diagram ratings. Another potential cause is a malfunctioning control system. If this is the case, replace the heater contactor if it's not functioning. Also, check auxiliary limit controls (humidistat, air flow proving switch, etc.) and reset, replace, or calibrate them as needed.
R
Robert DuranAug 25, 2025
What to do if my DriSteem Humidifier does not stop filling?
- D
  Daniel EvansAug 25, 2025
  If your DriSteem Humidifier won't stop filling, it might be due to a few reasons. First, ensure that the water conductivity is at least 100 micromhos/cm (2 gr/gal) or .34.2 mg/liter. You might need to add salt to the tank. Also, check the fill valve for any foreign matter that may be causing it to stick open. Inspect the drain valve to ensure it's closed and that the fill valve is installed correctly, noting the arrow for proper water flow. Finally, the humidifier may be in periodic drain and flush, so check the controller display.
N
Norman IbarraAug 28, 2025
Why is my DriSteem Humidifier short-cycling?
- A
  Anthony GonzalezAug 29, 2025
  If your DriSteem Humidifier is short-cycling, the controller cycle rate might be set too low. Review the controller cycle set point to resolve this issue.
J
Jesse CollinsSep 1, 2025
Why does my DriSteem Humidifier not stop filling?
- V
  Veronica JacksonSep 1, 2025
  If your DriSteem Humidifier doesn't stop filling, it could be due to several reasons. First, ensure the water conductivity is at least 2 grains/gallon (100 µS/cm) or 34.2 mg/L; adding salt to the tank might help. Check the fill valve for any foreign matter that might be causing it to stick open. Verify that the lever on the drain valve is in the closed position. Confirm that the fill valve is installed correctly, noting the arrow for proper water flow. Also, check the controller display to ensure the humidifier isn't in periodic drain and flush mode.
S
Stephen ObrienSep 5, 2025
What causes reduced output in DriSteem VAPORMIST Humidifier?
- R
  Rebecca BensonSep 5, 2025
  Reduced or no output from your DriSteem Humidifier, even with proper water level, could stem from a malfunctioning heater. Verify that the correct voltage is being applied to the heaters and compare the heater amp draw to the wiring diagram ratings. Alternatively, there might be an issue with the control system. If the heater contactor isn't functioning, replace it. Also, check the auxiliary limit controls, such as the humidistat and airflow proving switch, and reset, replace, or calibrate them as needed.
J
Jason MooreSep 8, 2025
How to fix short cycles in DriSteem Humidifier?
- C
  cmillerSep 8, 2025
  If your DriSteem Humidifier is short-cycling, the controller cycle rate might be set too low. Adjust the heater cycle time using the VAPOR-LOGIC keypad setup menu.

DriSteem VAPORMIST Specifications

General

Brand	DriSteem
Model	VAPORMIST
Category	Humidifier
Language	English

Related product manuals

DriSteem VAPORSTREAM VLC 9-1

DriSteem VAPORSTREAM VLC 50-2

Preview: DriSteem VAPORSTREAM VLC Series

DriSteem VAPORSTREAM VLC Series

Preview: DriSteem GTS

DriSteem RX-63-1

DriSteem RX-24-1

DriSteem XTP 006

DriSteem RX-75-1

DriSteem RX-126-2

DriSteem RX-144-2

DriSteem RX-264-4