installation instructions
1. Clean bathtub thoroughly and wipe dry
before applying rail. Contact surfaces must
be dry and free of soapy residue to assure
secure installation.
2. Loosen knob (A) until rail is wide enough to
slip on side of bathtub.
3. Place Safety Rail on bathtub with knob (A)
facing outside of tub and tighten until rail
feels tight and secure.
4. To test installation of rail, pull forward, back
and side to side. If rail slips or moves, make
sure surface is free of soapy film and is dry,
then replace at desired location
and retighten.
Safety Rail often requires retightening from time
to time. Check periodically before use and retight-
en as needed.
A
CAUTION Please use extreme care when installing
on fiberglass tub. DO NOT OVERTIGHTEN as the
clamp may crack the fiberglass.
Item # 12036
Shown
Rev.2.04.09.14
To Next Page
Loading...
