Viper Electric Scooter Page 7 of 16 Owner’s Handbook (Code: Viper_IFU)
Seat.
The seat can rotate 360° and locks in 45° settings. To
rotate, lift up the lever (A) located underneath the
left hand side of the seat and swivel seat. Release
the lever and carry on swiveling the seat until it locks
in position.
You can adjust the amount of legroom on the
scooter by sliding the seat back and forth. To slide
the seat, lift up the seat sliding handle (B). Located
on the right of the seat. Then adjust the seat to
correct position, release the handle and continue
sliding the seat until it locks in position.
To alter the backrest angle, pull up on the seat
recline lever, then adjust the backrest to the
required position and release the lever. Please note
if nobody is using the backrest when the lever is
operated, it will automatically spring the backrest
forward to fold the seat.
Armrest Adjustment.
To adjust the height of the armrest, loosen the
adjustment knob on the side of the armrest by
Turning anticlockwise. Adjust the armrest to the
required height and tighten the adjustment knob by
turning clockwise.
To adjust the angle of the armrest, flip up the
armrest and reposition the jam nut with a spanner to
alter the angle of the armrest.
Tiller Adjustment
The tiller can be adjusted into several positions.
1. Push (or pull) the lever on the scooter tiller
(shown below) to adjust the tiller to the position
you require.
2. Release the lever to lock the tiller.
Circuit Breaker.
The circuit breaker may trip when the scooter is
under excessive load or when travelling on steep
inclines. It will be more prone to tripping when the
scooter is low on battery charge. Under normal
conditions the circuit breaker button will protrude
by 2mm – 3mm. If the circuit breaker has tripped the
button will protrude by 7mm. To reset the circuit
breaker, push the button in and the scooter should
operate as normal.
The circuit breaker is located on the left hand side
of the rear of the frame, behind the back bumper.
To Next Page
Loading...
