Viper Electric Scooter Page 8 of 16 Owner’s Handbook (Code: Viper_IFU)
Freewheel Lever
The freewheel levers allows the automatic brake to be
disengaged so the scooter can be manually pushed
and/or manoeuvred. When in freewheel mode the
brakes are not applied so it should not be used when:
1. Somebody is sat on the scooter
2. If the scooter is left unattended
3. When the scooter is on a gradient
Engaged (Drive) Mode:
Pull the lever BACK completely and the scooter can be
driven by the motor.
Freewheel Mode:
Push the lever FORWARDS and switch the scooter off.
The scooter can now be pushed / moved manually.
Warning
The lever should only be set to
FREEWHEEL when on flat ground and
unoccupied by the user. Otherwise, there
is a risk of damage or injury.
.
Using the USB power socket
The scooter features a double USB power socket
which can be used to power or charge numerous
small devices such as satellite navigation systems,
tablet computers and MP3 players for example
The power socket is located in the front of the tiller.
To use facility, first rotate the cover as shown by the
arrow in the photo below. Then insert the USB cable
from the device in to the socket and switch on the
scooter.
Please note the USB sockets only operate when the
scooter is switched on.
To Next Page
Loading...
