DROPSA SMART2 - Parameter Setup Session; Lube Time Setting; Standby Time Setting (Timer); Standby Pulse Setting

10
7.4.3 Setup session
Press YES to enter SETUP.
Press NO to
g
o back to STANDBY or
A
LARM
(
if activated
)
.
Press SET to enter LUBE Time setup; use “-“ and “+” to change the value and
SAVE to save the new setting. Push NEXT to go to the next setup.
To modify STANDBY Time, when this function is controlled by a timer.
This parameter can be set only if
STANDBY type
is
timer
or
both
.
To modify STANDBY pulse when this function is controlled by a pulse register.
This parameter can be set only if STANDBY type is pulse or both.
Press YES to enter the EXTENDED MENU.
Press NO to re-initialize the machine.
Press SET to enter STANDBY Type setup; use “-“ and “+” to select Timer
–
Pulse - Both and SAVE to save the new setting. Push NEXT to go to the next
setu
p
.
To select LUBE Type: Timer – PS - SEP.
ONLY for PS: To modify DELAY Time for pump-OFF.
To modify LUBE Cycle.
To modify WAIT Time between two or more lube cycles.
Note: this parameter is displayed only if Lube or Prelube > 1
To select START mode system: START IN LUBRIC. / START IN STANDBY.
To modify PRELUBE Cycle.
To select the type of alarm electric contact: Norm. Close/ Norm.Open.
To set the day (DATE).
To set the month (DATE).
To set the year (DATE).
To set the hour (TIME).
To set the minutes
(
TIME
)
.
SET UP?
YES NO
LUBE Time 00m05s
SET NEXT
STANDBY 01m00s
SET NEXT
STANDBY 99i
SET NEXT
EXTENDED MENU?
YES NO
STANDBY TIMER
SET NEXT
LUBE Type TIMER
SET NEXT
DELAY Time 00m10s
SET NEXT
LUBE Cycles 2
SET NEXT
WAIT Time 00m10s
SET NEXT
START IN LUBRIC.
SET NEXT
PRELUBE 0
SET NEXT
A
LARM Norm.Open
SET NEXT
Day 1
SET NEXT
Month 1
SET NEXT
Year 2004
SET NEXT
Hour 0
SET NEXT
Minute 0
SET NEXT
BACK TO STANDBY OR
A
LARM
(
IF ACTIVATED
)
MACHINE
RE-INITIALIZATION
Date & Time Enabled
SET NEXT
To enable/disable Date and Time function