DROPSA SMART2 - VIP2004 Controller Operation; Typical Working Session; Typical System Start-up Sequence

9
7.4 SMART2 with built-in VIP2004 controller operation
7.4.1 Typical working session
Notice: prelube is always carried out according to prelube cycles set-up: if prelube cycles = ‘0’, no
prelube is run and the system will start operating either in standby or lube according to the pre-set
start mode.
7.4.2 Typical system start-up
LUBE X 2 TIMER
00m05s STOP
STANDBY 01m00s
setu
p
-> start
PRELUBE X 3 TIMER
00m05s STOP
PRELUBE will be carried out only when prelube cycles are set
(PRELUBE ≠ 0).
Whether prelube has been completely carried out (PRELUBE ≠ 0) or no
prelube was set (PRELUBE = 0), LUBE or STANDBY will start (see
start mode
)
.
www.DROPSA.com
SMART2 rel. 1.10
Jan 01-01-2004 0:00
setu
p
-> start
During standby, you can also see date and time when the function is
enabled (see setup).
STANDBY 99 I
setu
p
-> start
PRELUBE
CYCLES?
YES
PRELUBE
NO
LUBE
YES
STANDBY
LUBE
CYCLES
?
WAIT
NO