Caution
- If you continue to press down button (large ame) on the remote control,
the main burner should be largely ignited within about 10 seconds. If this is
not the case, you must close the gas tap and warn your installer;
- If the appliance ignites with a pop sound, you must close the gas tap and
contact your installer.
4.2.2.3 Switching off
Switch the appliance off by pressing the OFF button. The pilot burner will
also go out.
4.2.3 Temperature display
The room temperature can be indicated on the display in degrees Celsius (°C)
using a 24 hour clock or degrees Fahrenheit (°F) using a 12 hour clock.
➠
Simultaneously press OFF and (small ame), until the correct display appears.
4.2.4 Time
The display can indicate time.
After placing the battery or simultaneously pressing
(large flame) and
(small flame), the time indication will flash on the display and you will be able
to adjust the time.
➠
Simultaneously press and until the time indication ashes on the dis-
play.
➠
Press the button (large ame) to set the hours.
➠
Press the button (small ame) to set the minutes.
➠
Press OFF to return to the MAN position, or wait for the system to automatically
return to the MAN position.
4.2.5 Thermostat function
Using the thermostat function you can set two temperatures, which can be
controlled thermostatically. These temperatures are referred to as day tempe-
rature and night temperature.
The
Y
TEMP and • TEMP symbols on the display refer to day and night
temperature respectively.
The room temperature is compared to the set day/night temperature and
then the flame height is automatically controlled in order to reach the set
temperature.
To be able to use the day/night temperature function, the appliance must be
in the standby position.
!Caution
- Always leave the remote control at the same place, so that the thermostat is
able to ‘feel’ the room temperature;
- Make sure this place is free from inuences such as draught, heat from radia-
tors and direct sunlight.
To Next Page
Loading...
