Dru Metro 100XT - Setting Day;Night Temperatures; Activating Thermostat Mode

11
u s e r m a n u a l
English
Example
By using the
Y
TEMP function you can keep the day temperature at 20 °C; while
you use the • TEMP function at night to maintain a temperature of 15 °C.
4.2.5.1 Setting day/night temperature
By using the SET button, you will go through the following functions:
MAN →
Y
TEMP → • TEMP → (P*)TIMER → MAN
➠
Briey press the SET button to enter the
Y
TEMP or the • TEMP position.
➠
Press the SET button until the temperature on the display ashes.
➠
Set the required temperature by using the buttons (large ame) and
(small ame).
!Caution - The minimum temperature you can set is 5 °C / 40 °F;
- Control of the night temperature is switched o by lowering the temperature
until two stripes (“--”) appear on the display.
➠
Press the OFF button or wait until position
Y
TEMP or • TEMP appears on the
display.
4.2.5.2 Activating the thermostat function
For activating the thermostat function, you must proceed with the following
steps:
➠
Place the appliance in the standby (pilot burner) position using button
(small ame).
➠
Set the day/night temperature.
➠
Choose the
Y
TEMP or • TEMP function using the SET button.
4.2.6 Timer for thermostat function
Using the timer enables you to set two times per 24 hours for switching on
the day temperature and two times per 24 hours for switching on the night
temperature.
In order to control the night temperature, it should be set to at least 5 °C /
40 °F.
If the night temperature is set to the “-- ” position, the appliance will remain in
the standby position. The appliance will only switch on at the next switch-on
time of the day temperature.
The appliance must be in standby position in order to be controlled by the
timer.
UK