Dru Metro 100XT - Setting Timer Times

12
u s e r m a n u a l
English
Example of switch times
You have set a day temperature and night temperature of, for example, 20 °C
and 15 °C.
P1
Y
TIMER = 7 hours; the temperature will go to 20 °C at 7 am.
P1 • TIMER = 9 hours; the temperature will go to 15 °C at 9 am.
P2
Y
TIMER = 17 hours; the temperature will go to 20 °C at 5 pm.
P2 • TIMER = 22 hours; the temperature returns to 15 °C at 10 pm.
4.2.6.1 Setting times for the timer
To set the timer, proceed as follows:
➠
Set the day and night temperature as described above at section 4.2.5.1.
➠
Briey press the SET button to enter the (P*) TIMER position.
➠
Press the SET button until P1
Y
TIMER is displayed and the time ashes.
➠
Set the rst switch on time of the day temperature using the buttons (large
ame) and
(small ame).
➠
Briey press the SET button to set the next time of the cycle, P1 • TIMER.
➠
Successively set the times P2
Y
TIMER and P2 • TIMER.
➠
Press the OFF button or wait until position (P*) TIMER appears on the display.
4.2.6.2 Activating the timer function
Follow the steps below for activating the timer control:
➠
Place the appliance in the standby (pilot burner) position using button
(small ame).
➠
Set the day/night temperature if you have not yet done so; for this, see section
4.2.5.1.
➠
Set the timer times P1
Y
TIMER, P1 • TIMER, P2
Y
TIMER and P2 • TIMER.
➠
Choose the (P*) TIMER function using the SET button.
4.2.7 Automatic shut-off after 5 days
This function prevents consumption of gas energy in case of long-term non-
activity. The system will automatically shut off the pilot flame when the appli-
ance has not been active for a period of 5 days.
4.2.8 Replacing the battery
If the battery is almost empty, the display will show “BATT”.
To replace the battery, proceed as follows:
➠
Remove the cover at the back side of the remote control.
➠
Disconnect the 9V block battery from / connect the 9V block battery to the con-
nector.
UK