Page 3For technical questions, please call 1-888-866-5797.Item 63477
Specifications
Electrical Rating 120 VAC / 60 Hz / 8.5 A
Power Cord Length 25'
Maximum Flow @ 0' Head Lift 4400 GPH
Maximum Head Lift @ 0 GPH Flow 40'
Discharge Port 1-1/4" NPT
Discharge Port Adapter 1-1/4" NPT to 3/4" garden hose thread
Installation
The submersible motor Pump must be installed in a stationary position with either:
a. A fixed pipeline or
b. A flexible hose pipe.
Please note!
1. Do not install the Pump by suspending it
unsupported from its delivery pipe or power cord.
The Pump must be suspended from the handle
or be placed on the bottom of the basin.
To ensure that the Pump works properly, keep the
bottom free from sludge and dirt of all kinds.
2. If the water level sinks too low, any sludge in the
basin will dry out and stop the Pump from starting.
To help ensure the Pump will start as required,
check the Pump regularly with start-up tests.
Power Supply
1. The Pump is equipped with a shock-proof plug
according to regulations. The Pump is designed
to be connected to a 120 VAC, 60 Hz, Ground
Fault Circuit Interrupter (GFCI) protected socket.
2. Make sure that the socket is sufficiently
secured and is in excellent condition.
3. When the plug is inserted into the socket,
the Pump will start operating.
4. WARNING: To prevent death from electric
shock, Pump must be connected only to
a GFCI protected outlet.
WARNING! If the power cord or plug is damaged,
do not use the Pump. The power cord or plug
may only be repaired by a certified electrician.
Areas of use
1. This Pump is designed to pump water only.
2. This Pump is designed to be used for:
• Removing ground water from
basements and outdoor job sites
• Very high flow
3. This Pump should NOT be used for:
• Continuous run, fountain/pond water features
• Basement sump applications
• Septic or sewage systems
• Potable water systems
4. This Pump can also be used to transfer water
(e.g. household, farming, plumbing).
To Next Page
Loading...
