We recommend using minumum12 Ga
speaker cables to acquire the intended
performance & efficiency. Run the speaker
cables from your speakers to the amplifier's
mounting location. Ensure these are ran
separately and away from high current
cables and if possible the RCA cables as well.
In all cases where cables are penetrating the
vechile's chassis use grommets to protect
the cable. Connect the speaker wires
according to the terminals on the speaker(s).
Strip 3/8”/ 1 cm of insulation of the end of
each cable and twist the cable strands
together tightly. Make sure there are no
stray strands that could touch other cables
or terminals as it can cause a short circut.
Crimp spade plugs over the end of the cable
or tin the ends with solder to provide a solid
terminal. Connect the cable ends to the
amplifier as shown in the diagram. Bridged
speaker connection will add the channels
together (monophonic). Bridged speaker
connection impedance is 4 ohm only !
Ga como mínimo para adquirir el rendimiento y la
altavoces desde sus altavoces hasta la ubicación de
coloquen por separado y lejos de los cables de alta
corriente y, si es posible, también de los cables
atraviesen en el chasis del vehículo, utilice ojales
altavoces de acuerdo con los terminales de los
sueltas que puedan tocar otros cables o terminales,
los altavoces con puente es de 4 ohmios
solamente!
14
To Next Page
Loading...
Need help?
General
