• Measure the speaker impedance & that it
is in accordance with the configuration.
• Inspect the power cable for shorts along
with vehicle chassis.
• Measure the speaker impedance & that it
is in accordance with the configuration.
• Check speaker shorts.
• Ensure airflow around the amplifier is
sufficient & that the amplifier is not installed
in areas of excessive vibration & upside down.
AUDIO OUTPUT INSUFFICIENT -
DISTORTED SOUND
• Ensure that the gain settings on the
amplifier is matched with the output level of
the head unit.
• Adjust the head unit volume.
• Check speaker shorts.
• Adjust the crossover frequencies in
accordance with the setup.
• If no output at all, check the RCA connections
& the cable itself.
• Disconnect the signal input to the
amplifier, then turn it on and off.
a) If the noise is cancelled, then connect a
delay turn on module on the REM wire
running from the source unit to the amplifier.
b) Use another 12V source for REM lead to
the amplifier. If the noise is cancelled, use a
relay to isolate the amplifier from the turn
on thump.
FUSIBLE FUNDIDO
• Inspeccione el cable de alimentación en busca de
CALENTAMIENTO EXCESIVO
amplificador sea suficiente y que el amplificador no
SALIDA DE AUDIO INSUFICIENTE - SONIDO
DISTORTADO
en el amplificador coincida con la salida
• Ajuste las frecuencias de crossover de acuerdo
RUIDO DE POP AL ENCENDER
• Desconecte la entrada de señal al amplificador,
a) Si se cancela el ruido, utilice modulo de retardo
de encendido remoto desde la unidad principal a el
To Next Page
Loading...
