DSC 3G2080E

_______________________________________
[827] Periodic Test Transmission
Default (Periodic Test)
_______________________________________
[828] Periodic Test With Trouble
Default (Periodic Test With Trouble)
_______________________________________
[829] DLS Remote Programming Begin
Default (Remote Programming Begin)
_______________________________________
[830] DLS Remote Programming End
Default (Remote Programming End)
_______________________________________
[831] SA Remote Programming Begin
Default (Remote Programming Begin)
_______________________________________
[832] SA Remote Programming End
Default (Remote Programming End)
_______________________________________
[833] Installer Lead In
Default (Local Programming Begin)
_______________________________________
[834] Installer Lead Out
Default (Local Programming End)
_______________________________________
[835] Firmware Update Begin
Default (Firmware Update Begin)
_______________________________________
[836] Firmware Update Successful
Default (Firmware Update Successful)
_______________________________________
[837] Firmware Update Fail
Default (Firmware Update Fail)
_______________________________________
[838] Delinquency
Default (Delinquency)
_______________________________________
[839] Keypad Lockout
Default (Keypad Lockout)
_______________________________________
[840] Event Log 75% full
Default (EventLog Near Full)
_______________________________________
[841] FTC Trouble
Default (fail to communicate trouble)
_______________________________________
[842] FTC Restore
Default (fail to communicate restore)
_______________________________________
[843] Panel Absent Trouble
Default (Panel Communications Trouble)
_______________________________________
[844] Panel Absent Trouble Restore
Default (Panel Communications Restore)
_______________________________________
[845] Module Reprogramming
Default (Communicator Programming Updated)
_______________________________________
[846] Firmware Update
Default (Communicator Programming Updated)
_______________________________________
[850] Module
Default (Module)
_______________________________________
[851] Stay Arm
Default (Stay Arm)
_______________________________________
[852] Away Arm
Default (Away Arm)
_______________________________________
[853] Night Arm
Default (Night Arm)
_______________________________________
[854] Disarm
Default (Disarm)
_______________________________________
[855] Activate Command Output 1
Default (Activate Command Output 1)
_______________________________________
[856] Activate Command Output 2
Default (Activate Command Output 2)
_______________________________________
[857] Activate Command Output 3
Default (Activate Command Output 3)
_______________________________________
[858] Activate Command Output 4
Default (Activate Command Output 4)
_______________________________________
[859] Deactivate Command Output 1
Default (Deactivate Command Output 1)
_______________________________________
[860] Deactivate Command Output 2
Default (Deactivate Command Output 2)
_______________________________________
[861] Deactivate Command Output 3
Default (Deactivate Command Output 3)
_______________________________________
[862] Deactivate Command Output 4
Default (Deactivate Command Output 4)
_______________________________________
[863] Bypass
Default (Bypass)
_______________________________________
[864] Unbypass
Default (Unbypass)
63