DSC 3G2080E

_______________________________________
[865] Status Request
Default (Status Request)
_______________________________________
[866] Alarm Memory Request
Default (Alarm Memory Request)
_______________________________________
[867] Help
Default (Help)
_______________________________________
[868] Pay As You Go Balance Request
Default (Balance Request)
_______________________________________
[869] Keypad Message
Default (Keypad Message)
_______________________________________
[870] Function Successful
Default (Successful)
_______________________________________
[871] Function Failure
Default (Unsuccessful)
_______________________________________
[872] Invalid Command
Default (Invalid Command)
_______________________________________
[873] System Stay Armed
Default (Stay Armed)
_______________________________________
[874] System Away Armed
Default (Away Armed)
_______________________________________
[875] System Night Armed
Default (Night Armed)
_______________________________________
[876] System Disarmed Ready
Default (Disarmed Ready)
_______________________________________
[877] System Disarmed, Not Ready
Default (Disarmed Not Ready)
_______________________________________
[878] System In Alarm
Default (is in Alarm)
_______________________________________
[879] Trouble Label
Default (Service is Required)
_______________________________________
[880] No Alarms in Memory
Default (No Alarms in Memory)
_______________________________________
[881] Pay As You Go Balance
Default (Pay as you go balance:)
_______________________________________
[882] Pay As You Go Message
Default (*123#)
_______________________________________
[883] Response Code
Default (Response Code)
_______________________________________
Receiver Diagnostic Testing
[901] Diagnostic Test Transmission
[1] Ethernet 1 Default (OFF).
[2] Ethernet 2 Default (OFF).
[3] Cellular 1 Default (OFF).
[4] Cellular 2 Default (OFF).
[902] Load Programming Template
[1] Connect Alarm -Ethernet.
[2] Connect Alarm - Cellular.
[961] Cellular Inactivity Timeout
Default (41)
Valid entries from, 00 to FF.
System Information (Read Only)
[971] EEPROM version
Default (05400402)
[972] Virtual Keypad Language Version
[976] Radio Configuration File Version
[977] Cellular NetworkProvider - MCC/MNC Code
[978] Cellular Network Type
00 GPRS (2G)
01 EDGE (2G)
02 WCDMA (3G)
03 HSDPA (3G)
04 LTE (4G)
05 LTE Advanced (4G)
06 CDMA (2G)
07 EVDO (3G)
[979] Cellular Network CSQ
[980] Radio Reset Codes
[981] Radio Type
[982] Radio Firmware Version
[983] Firmware Update Diagnostics Section
[984] Communicator Status
[985] Radio Initialization Status
[986] System Toggle Options 4
[1] Remote Shutdown Enable Default (OFF).
64