8
Zone Bypassing Attribute
This attribute allows the user to manually bypass zones if bypassing requires an access code.
Remote Access Attribute
This attribute allows the user to specify which user access codes can be used for remote access
via SMS Interactive.
Bell/Siren Squawk Attribute
This attribute is used to determine whether an access code should generate an arming/disarm-
ing squawk when the away function key is pressed on a wireless key. Contact your installer to
have this programmed. The Master code cannot use the Bell/Siren Squawk attribute, but the
code is required to enable the Bell/Siren for other codes.
NOTE: This feature cannot prevent the Arm/Disarming squawks from being generated if an
access code assigned to a wireless key is manually entered at a keypad.
Erasing an Access Code
To erase a code, select the code and enter as the first digit. If is entered, the system will
delete the code (including the associated prox tag) immediately and the user will be returned to
select another code.
Proximity Tag Enrollment (PT4/PT8)
Proximity (prox) tag readers are only available on WT5500P keypads. Refer to the label on top of
the keypad to confirm which model you have.
Enrolling Proximity Tags
1. Enter [
][5][Master Code] to enter User Code Programming.
2. Scroll to the desired user code (01-16, or 40 for the master code) then press [
].
3. Enter your desired 4 or 6-digit user access code. The following message will be displayed
after the user access code is entered:
4. Place the prox tag near the tag reader ( ) at the left side of the display to assign it to the user
code. The following message will be displayed:
5. If an attempt is made to assign a prox tag to an existing user code that has an associated prox
tag, the following message will be displayed:
Select another user code or erase the existing user code and associated prox tag and re-enroll
with the new prox tag. Return to Step 2 for instructions on how to enroll a user code.
NOTE: To exit the process at anytime, press [#].
Erasing a User Code/Proximity Tag
Enter [
][5][Master Code], select the desired user code. Enter [] to erase the code and associ-
ated prox tag. The keypad will display the user number (e.g., 01) with a letter “P” if a user code
has already been programmed and a letter “T” if a code and prox tag have been programmed.
NOTE: User 40 for the master code cannot be deleted; an attempt to delete this user code will
delete the prox tag only. The prox tag must be re-enrolled before it can be used again.
Proximity Tag Operation
6. Place the prox tag near the tag reader
() at the left side of the display to arm/disarm your
system. When arming the system, the following message will be displayed:
7. When disarming the system, the following message will be displayed:
Present Tag or
Press # to Exit
Tag Enrolled
Successfully
Duplicate
Tag/User Code
Exit Delay in
Progress
To Next Page
Loading...
Need help?
General
