10
Viewing the Event Buffer
The event buffer will show you a list of the last 500 events that have occurred on your system.
1. Press [Master Code].
2. To select Event Buffer viewing, press .
3. The keypad will display the event number and the time and date. Press to switch
between this information and the event details.
4. Use the buttons to scroll through the events in the buffer.
5. To exit event buffer viewing, press .
To Change or Program SMS Phone Numbers
This section tells you how to program your SMS phone numbers:
1. Enter [
][6][Master Code] to enter the Master User Functions of the system.
2. Use the buttons to scroll to the SMS programming prompt.
3. Press at the prompt to select the SMS phone numbers or to see your GSM phone num-
ber. The following message is displayed:
• To see your GSM phone number use the buttons to scroll to the following mes-
sage. Then press
to view the number.
4. Press to select Phone No. 1. The following 26-digit phone number screen is shown.
5. Program a new phone number or delete an existing phone number as follows:
• To Enter a new telephone number (e.g., 4168889999), enter your numbers starting at the
first F (after the D), see below.
• To Delete an existing phone number, replace the letter D with an F by pressing [
][6][]
and then press # to exit. This will delete the phone number.
6. Use the buttons to scroll to another Phone No. to be programmed.
7. Repeat from Step 4 to enter more phone numbers. To exit the process at any time, press [#].
Late to Open
This features allows a user to be notified if their alarm system is not disarmed by a programmed
time of day.
NOTE: The Late to Open feature requires the monitoring station to forward calls to the user. Verify
with the installer whether this function is active.
[9] Late to Open Enable/Disable
The
Late to Open feature
enables or disables the Late to Open time programmed in [0].
It is typically used to track children after school. For example, if the parents get home from work
at 5pm, and a child gets home at 4pm. The programmable timer could be set for 4:15. If the
system is not disarmed at this time an alert would be sent to the monitoring station. The keypad
will display "Late to Open is Enabled" and sound 3 beeps if is pressed within the User Func-
Select Option <>
SMS Programming
Press (
) for <>
Phone No.1 P
“P” denotes whether the phone number has
been programmed.
Press () for <>
GSM Phone No.
Pressing () here shows your GSM number
DFFFFFFFFFFFFFFF
FFFFFFFFFFFFPH#X
X=1 to 8 to indicate the phone number screen
being programmed (e.g.,X=1 for Phone No. 1)
D4168889999FFFFF
FFFFFFFFFFFFPH#1
Do Not delete the remaining F’s
F4168889999FFFFF
FFFFFFFFFFFFPH#1
To Next Page
Loading...
Need help?
General
