Section 1.2: Installing The NT9010
13
1.2.8 Other NT9010
Options
After all zones have passed the Placement Test, Flash Programming will move to the
advanced programming sections. If you do not need to do more programming, press [#] to
exit.
If you need to complete programming not covered by Flash Programming, please see
Chapter 2: Advanced Programming on page 15 . For example, you may need to change
the definitions of one or more zones. This programming is described in 2.3.1 Zone Defini-
tions on page 33.
1.2.9 Deleting
Wireless
Devices
To remove a wireless device from the system, you will need to use the advanced program-
ming sections.
1. Press [✱][8], then enter the Installer’s code. The default Installer’s code is [5555].
3. When prompted, press [2] to go to advanced programming.
4. Enter [804], then enter the 2-digit number of the zone you want to delete (01 - 32).
The system announces the current serial number for the zone.
5. Program the serial number for the zone as [000000]. The wireless device for the
zone will be removed.
NOTE: You may need to remove power from the system and then restore it to
clear troubles caused by deleted zones.
To Next Page
Loading...
