Chapter 2: Advanced Programming
42
2. If the reporting code for an event is programmed as anything from [01] to [FE] the
system will send the programmed reporting code.
3. Bypassed zones will not be identified when partial closing of the system occurs.
NOTE: The zone number for Zone Low Battery and Zone Fault events will not
be identified when Programmed SIA is used.
Communicator Format . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Section [360]
SIA Sends Automatic Reporting Codes . . . . . . . . . . . . . . .Section [381], Option [3]
Communicator Call Direction Options. . . . . . . . . . . . . . . . . Sections [361] to [368]
SIA Identifiers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Appendix B
Pager Format
The Communicator Format option for either telephone number can be programmed for
Pager Format. If an event occurs and the Communicator Call Direction options direct the
call to a telephone number with the Pager Format selected the system will attempt to page.
When calling a pager extra digits will be required to make it work properly.
The following is a list of Hex digits and what function they perform:
HEX (B) - simulates the [✱] key on a Touch Tone telephone
HEX (C) - simulates the [#] key on a Touch Tone telephone, or
end of telephone number marker
HEX (D) - forces the system to search for dial tone
HEX (E) - forces the system to pause for 2 seconds
HEX (F) - end of telephone number marker
The system will attempt to call the pager one time. After dialing the digits in the telephone
number the system will send the account number and reporting code followed by the [#]
key (Hex [C]).
There is no ringback when using Pager Format. The system has no way of confirming if the
pager was called successfully. A failure to communicate trouble will only be generated once
the maximum number of attempts has been reached.
NOTE: Do not use the digit C in a reporting code when using Pager Format. In
most cases, the digit C will be interpreted as a [#], which will terminate the page
before it has finished.
NOTE: If the system detects a busy signal, it will attempt to page again. It will
make the maximum number of attempts programmed in section [160].
NOTE:Force dialing should be disabled when using Pager format.
NOTE: When using Pager format, you must program two pauses (hex digit E) at
the end of the telephone number.
Communicator Format Options. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Section [360]
2.3.12
Communicator
Reporting
Codes
Unless you are using Automatic Contact ID or Automatic SIA formats, reporting codes must
be programmed in order for the system to report events to the central station.
Reporting codes are two digits and can use hexadecimal digits A through F. To disable a
reporting code, program it as “FF” (default setting) or “00”. For a complete description of
To Next Page
Loading...
