DSC PC1555 - PGM Output Attributes; PGM Attribute Defaults (Y = Attribute ON; N = Attribute OFF):

Programming Work sheets
33
[017] Fifth System Option Code
Default Option ON Off Section Page #
ON I________I 1 WLS Key Does Not Use Access Codes* WLS Key Uses Access Codes 5.17 23
OFF
I________I 2-7 For future use
OFF
I________I 8 Squawk on Away Arming/Disarming OnlyBell Squawk on all Arming/Disarming 5.17 23
*This option must be enabled when using a PC5132 v2.1 or earlier.
[020] Keypad Zone Assignments (Section 2.12 “Keypad Zones” on page 7)
NOTE:Only one keypad may be assigned to a zone.
Default
00 I________I_______I Keypad (slot 1) Zone Valid entries are zones 01-08
00
I________I_______I Keypad (slot 2) Zone Valid entries are zones 01-08
00
I________I_______I Keypad (slot 3) Zone Valid entries are zones 01-08
00
I________I_______I Keypad (slot 4) Zone Valid entries are zones 01-08
00
I________I_______I Keypad (slot 5) Zone Valid entries are zones 01-08
00
I________I_______I Keypad (slot 6) Zone Valid entries are zones 01-08
00
I________I_______I Keypad (slot 7) Zone Valid entries are zones 01-08
00
I________I_______I Keypad (slot 8) Zone Valid entries are zones 01-08
[030] Zone Loop Response Options
Default Option ON Off Section Page #
OFF
I________I 1 Zone 1 is Fast Loop Response Zone 1 is Normal Loop Response 5.24 25
OFF
I________I 2 Zone 2 is Fast Loop Response Zone 2 is Normal Loop Response 5.24 25
OFF
I________I 3 Zone 3 is Fast Loop Response Zone 3 is Normal Loop Response 5.24 25
OFF
I________I 4 Zone 4 is Fast Loop Response Zone 4 is Normal Loop Response 5.24 25
OFF
I________I 5 Zone 5 is Fast Loop Response Zone 5 is Normal Loop Response 5.24 25
OFF
I________I 6 Zone 6 is Fast Loop Response Zone 6 is Normal Loop Response 5.24 25
OFF
I________I 7-8 For future use