DSC PC5020 User Manual

PC5020
Wiring Trikdis GT+ Cellular Communicator and
Programming the Panel
• The communicator should be installed and maintained by qualified personnel.
• Prior to installation, it is advised to read full device installation manual carefully in order to
avoid mistakes that can lead to malfunction or even damage the equipment.
• Disconnect the power supply before making any electrical connections.
• Changes, modifications or repairs not authorized by the manufacturer shall void your rights
under the warranty.
CAUTION
Schematics forwiring the communicator
to the security control panel
Following the schematics provided below, wire the communicator to the control panel.
trikdis.com
DSC PC5020
EGND
T-1
R-1
Z8 Z6 Z4 Z2
COM COM COM COM GRN YEL BLK RED
AUX
- +
AC
-BELL+
PGMPGM
24
13
Z7 Z5 Z3 Z1
TIP
RING

DSC PC5020 Specifications

General

Model	PC5020
Type	Control Panel
Compatibility	DSC PowerSeries
Keypads	Up to 8
Partitions	2
Input Voltage	16.5V AC
Zones	8
Communication	IP, GSM, and POTS
Event Buffer	512
User Codes	48
Battery Backup	7Ah battery
Compatible Keypads	PK5501, PK5508, PK5516

Summary

General Safety and Installation Precautions

Important Safety Guidelines

Qualified personnel must install and maintain the communicator. Read the manual before installation and disconnect power before wiring.

Wiring Schematics for Control Panel

Communicator to Panel Connection

Follow the provided schematics to wire the Trikdis GT+ cellular communicator to the security control panel.

Communicator Operation Indicators

LED Status and Descriptions

Details the LED indications for Network, Data, Power, Trouble, and Band, explaining their meaning and status.

Setting Up the GT+ Communicator with the App

Initial System Configuration Steps

Add system, enter IMEI, select security company (DSC), and choose panel model (PC5020) via the Protegus app.

Device and Panel Identification

Configure Object ID and Module ID, then proceed with panel setup by pressing 'NEXT'.

Finalizing App Configuration

Wait for configuration writing and press 'Add to Protegus2' to complete the setup.

Completing App Setup and System Checks

System Naming and Transfer

Enter system name, skip or personalize, and optionally transfer system ownership via email.

Performing System Checks

Create an event (arming/disarming or alarm) and verify it is received by the CMS and Protegus app.