DSC Power Series PC1616 User Manual

DSC Power Series PC1616 - Quick Guide
https://alpha.adt.com/help/20.html[11/8/2018 11:27:26 PM]
DSC Power Series PC1616 - Quick Guide
For a detailed review of the entire system, please view the DSC Power Series 1616 manual.
There are two variations of the keypad for this system. This quick guide contains information for both,
indicated by the use of ‘OR’ in the instructions.
« Help Center
Arm &
Disarm the
System
Battery Bypass
Protected
Areas
Date &
Time
Settings
Chimes &
Beeps
Reset Security
Codes
Trouble
Conditions
Volume
Arm and Disarm
Arm:
To arm all sensors in AWAY mode when you are leaving the premises, press and hold the [AWAY]
button.
To arm all sensors in STAY mode when you are not leaving the premises, press and hold the [STAY]
button OR enter your [security code] and do not leave the premises.
To arm all in NIGHT mode, where both the interior and exterior are armed, press [*] + [1] after first
Select

DSC Power Series PC1616 Specifications

General

Partitions	2
User Codes	48
Event Buffer	500 events
Keypads Supported	8
PGM Outputs	2 (expandable to 14)
Zones	6 on-board, expandable to 16
Communications	PSTN
Power Supply	16.5VAC
Battery Backup	12VDC

Summary

Arm & Disarm the System

Arming the System

Instructions for arming the system in AWAY, STAY, and NIGHT modes using keypad commands.

Disarming the System

Procedure to disarm the security system by entering your security code.

Battery Information

Battery Status and Replacement

Details about the system battery, AC power loss, low battery indication, and replacement guidance.

Bypass Protected Areas

Zone Bypassing Operations

Instructions for bypassing and unbypassing zones using keypad commands to arm the system selectively.

Change Date and Time

Setting System Date and Time

Guide to changing the system's date and time using keypad input in specified formats.

Chimes and Beeps

Door Chime Function Control

How to turn the door chime function on or off using keypad commands.

Reset Procedures

Clearing Alarm and Event History

Procedures for clearing alarm events, fire alarms, and trouble conditions from the display.

Security Codes Management

Programming and Erasing User Codes

Instructions for programming, adding, and erasing user access codes for system access.

Pre-programmed User Levels

Overview of pre-programmed user levels like Master, Supervisor, and Duress codes with their capabilities.

Trouble Conditions

Trouble Condition Handling

How to silence, view, and override trouble condition alerts on the keypad.

Volume Settings

Keypad Volume Adjustment

Information regarding the adjustability of the volume on the DSC PC1616 keypad.