DSC Power 864 - Page 14

Automatic Your installer may have set up your system to arm at a pre-programmed time. If automatic
Arming arming has been programmed, when the system reaches the programmed auto-arm time,
the keypad buzzers will sound for one minute, and LCD5500Z keypads will display "System
Arming in Progress".
During this one-minute warning time, you may be able to cancel or postpone auto-arming
by entering your [access code]. Ask your installer for more information.
Your installer may have set up the system so that users with a [master code] can control the
auto-arm schedule at the keypad. If so, master users will be able to turn the auto-arming
function on or off, and program the time at which the system will auto-arm each day.
To turn automatic arming on or off:
1. Press ®®, then [master code],
2. Press © to turn automatic arming on or off. The keypad will beep 3 times when auto¬
arm is turned ON, and once when it is turned OFF.
3. To exit programming, press ®.
To program the auto-arm time:
1. Press ®©, then [master code],
2. Press @.
3. On an LCD5500Z keypad, scroll to the day of the week you want to program using the
C<][>5 keys, then press ®.
On a PC55XXZ or LCD5501Z keypad enter the number of the day of the week (1-7)
you want to program (e.g., for Sunday, press [1 ], for Friday press [6]).
4. Enter the auto-arm time using the 24Hr format (0000 - 2359). For example, to set the
time for 1:00pm, enter (1300). To prevent auto-arming on a particular day, enter (9999)
for the auto-arm time.
5. To program the time for another day, repeat steps 3-4. To exit programming, press @
NOTE: The correct system time and date must be programmed in order for the
auto-arm feature to function properly. Please see "Setting the Time and Date" on page