DSC Power 864 - Section 5: Customizing Your System; Programming Access Codes

Recalling
Bypassed
Groups
To recall the last set of bypassed zones:
1. Press®©, then your [access code] (if necessary).
2. Press®®.
3. To exit bypassing mode and return to the Ready state, press ®.
A Bypass Group is a selection of zones programmed into the system. If you bypass a group
of zones on a regular basis, you can program them into the Bypass Group, so that you do
not have to bypass each zone individually every time. One Bypass Group can be pro¬
grammed on each partition.
To program a Bypass Group:
1. Press ©©, then your [access code] (if necessary).
2. Enter the two-digit numbers (01-64) of the zones to be included in the Bypass Group.
On LCD5500Z keypads, you can also use the C<][>> keys to find the zone to be
included in the bypass group, and then press © to select the zone.
3. To save the selected zone into the group, press ® ©.
4. To exit bypassing mode and return to the Ready state, press ©.
To select a Bypass Group when arming the system:
1. Press ® ©, then your [access code] (if necessary).
2. Press ©©. The next time the system is armed, the zones in this group will be
bypassed.
3. To exit bypassing mode and return to the Ready state, press ©.
NOTE: Bypass Croups are only recalled if the system is armed/disarmed after pro¬
gramming the bypass group..