Approvals information
NOTICE TO USERS, INSTALLERS, AUTHORITIES HAVING JURISDICTION AND OTHER INVOLVED PARTIES
This product incorporates field-programmable software. In order for the product to comply with the requirements in
CAN/ULC-S559.
Standard for Control Units for Fire Alarm Systems, certain programming features or options must be limited to the
specific values or not used at all as indicated below.
Program Feature or
Option
Permitted in ULC-
S559
Possible Settings
Settings Permitted in
S559
Supervision (Active) Yes
180s
200s
180s (90s Heartbeat)
300s
180s (90s Heartbeat)
(Active)
Supervision (Passive) Yes
Daily, Weekly, Monthly test
transmissions
Daily Test Enabled
(passive)
SMS Command and
Control
No Enable/disable Disabled
In Connect24, the installer must select an account type. These are the account types available for ULC in
C24: ULC Commercial Fire – Active
ULC Commercial Burg – Active
ULC Commercial Fire – Passive
ULC Commercial Burg – Passive
ULC Residential – All configurations
ULC Commercial Fire Active Dual channel
ULC Commercial Fire Passive Dual channel
IMPORTANT INSTALLATION NOTICE - TL280LE-AU / LE2080-AU
The radio requires an appropriate network provider to be selected during the installation process.
Telstra:Enter Installer's programming [*][8][Installer's code][851][019], and enter 01 to select Telstra.
Vodafone:Enter Installer's programming [*][8][Installer's code][851][019], and enter 02 to select Vodafone.
If Optus is the carrier, select the Telstra profile 01.
Spark: Enter Installer's programming [*][8][Installer's code][851][019], and enter 03 to select Spark.
Failure to select the correct network profile during the initial installation may interfere with SIM card
provisioning or the radio's ability to remain attached to the home network.
To Next Page
Loading...
