DSC T-LINK TL250 User Manual

T-Link TL250/TL300
Network Internet
Alarm Communicator
Software Version 1.20
Installation Manual

DSC T-LINK TL250 Specifications

General

Resolution	240 x 320 pixels
Battery	1000 mAh
Display	2.4 inch
Memory	32 MB
Expandable Memory	MicroSD up to 8 GB
Network	GSM 900 / 1800 MHz

Summary

Section 2: Quick Start Guide

Installation and Testing Procedures

Steps for determining mode, location, wiring, mounting, and testing the system.

Section 3: Bell Follower Installation (Mode 1)

Setup, Connections, and Wiring

Installing TL250 for Bell Follower, power connection, UL/ULC limits, and wiring diagram.

Section 4: Stand-alone Installation (Modes 2&3)

Mode 2 & 3 Configuration and Wiring

Wiring diagrams for 4-zone (Mode 2) and 12-zone (Mode 3) stand-alone setups.

Section 5: Standard Installation (Mode 4)

Panel Setup and Wiring to DSC Panels

Mounting TL-Link and connecting to compatible DSC panels like PC4020/PC5020.

UL Fire Systems Power Routing

Wiring diagram for AC and battery leads in UL listed commercial fire systems.

Section 6: DVACS Installation (Mode 5)

DVACS Panel Connectivity and Events

Connecting T-Link to DVACS panels, event protocols, and example reports.

Section 7: TL300 Telephone Simulation

TL300 Installation, Wiring, and Operation

Steps for TL300 installation, wiring diagram, and communication flow overview.

Section 8: T-Link Operation Details

Remote Control, Programming, and IP Settings

Module control, programming methods, and IP address configuration.

Section 9: Programming Guide

Essential Programming Info and PC4020 Guide

Required information before programming and PC4020 panel programming steps.

PC5020, DVACS, and TL300 Programming