35
Appendix D: Contact ID Reporting Codes
Contact ID Format:
MEDICAL:
100 Medical Emerg-PersonalEmergency-#
101 Pendant Transmitter Emerg-Personal Emergency-#
102 Fail to report in Emerg-Fail to check in-#
FIRE ALARMS:
110 FIRE Fire-Fire Alarm-#
111 SMOKE Fire-Fire Alarm-#
w/VERIFICATION
112 Combustion Fire-Combustion-#
113 WATERFLOW Fire-Water Flow -#
114 Heat Fire-Heat Sensor-#
115 Pull Station Fire-Pull Station-#
116 Duct Fire-Duct Sensor-#
117 Flame Fire-Flame Sensor-#
118 Near Alarm Fire-Near Alarm -#
PANIC ALARMS:
120 Panic Alarm Panic-Panic-#
121 DURESS Panic-Duress- User 000, or duress zone number on low end panels
122 SILENT Panic-Silent Panic-#
123 AUDIBLE Panic-Audible Panic-#
124 Duress-Access Granted Panic-Duress Access Grant-#
125 Duress-Egress Granted Panic-Duress Egress Grant-#
BURGLAR ALARMS:
130 Burglary Burg-Burglary-#
131 PERIMETER Burg-Perimeter-#
132 INTERIOR Burg-Interior-#
133 24 HR BURG (AUX) Burg-24 Hour-#
134 ENTRY/EXIT Burg-Entry/Exit-#
135 DAY/NIGHT Burg-Day/Night-#
136 Outdoor Burg-Outdoor-#
137 TAMPER Burg-Tamper-#
138 Near Alarm Burg-Near Alarm-#
139 Intrusion Verifier Burg-Intrusion Verifier-#
GENERAL ALARMS:
140 General Alarm Alarm-General Alarm-#
141 Polling Loop Open Alarm-Polling Loop Open
142 POLLING LOOP SHORT (AL) Alarm-Polling Loop Short
143 EXPANSION MOD FAILURE Alarm-Exp. Module Tamper-#
CCCC Q EEE GG ZZZ
CCCC
Q
EEE
ZZZ
= customer (subscriber account number)
= event qualifier, E = new Event, R = Restore
= event code
= zone ID number reporting the alarm (001-099), or user number for open/close
reports.
Note: System status messages (e.g.,AC Loss, Low Battery etc.) contain zeros in
the ZZZ location
Subscriber ID #
XXXX
Event Qualifier
Event or Restore
E or R
Event Coded
000
Partition #
00
Zone or User #
C000 or U000
To Next Page
Loading...
