EasyManua.ls Logo

DSC PowerSeries Neo LE2080

DSC PowerSeries Neo LE2080
65 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
TL280LE(R)
Internet and LTE/HSPA Dual-Path Alarm
Communicator
LE2080(R)
LTE/HSPA Alarm Communicator
3G2080(R)E
HSPA Cellular Alarm Communicator
TL2803G(R)E
Internet and HSPA Dual-Path Alarm Communicator
TL280(R)E
Internet Alarm Communicator
Installation Manual 5.x
Warning: This manual contains information on limitations regarding product use and function and information on the
limitations as to the liability of the manufacturer. The entire manual should be carefully read.
Please note that not all models and features listed are available in all markets.

Table of Contents

Questions and Answers:

DSC PowerSeries Neo LE2080 Specifications

General IconGeneral
BrandDSC
ModelPowerSeries Neo LE2080
CategoryCell Phone
LanguageEnglish

Summary

General Information

Safety Information

Essential safety precautions and warnings for installers and users of the system.

Panel Mounting and Features

Panel Mounting

Guidelines for physically installing the communicator module within compatible DSC panels.

Installation Requirements and Compatibility

EN50131-1 Installation Requirements

Specific programming options required for EN50131-1 compliant installations.

Pre-Installation and Configuration

Pre Installation Configuration

Initial setup steps including encryption and installation configuration overview.

Communicator Installation Configuration

Guidelines for skilled installation and environmental considerations for the communicator.

Communicator Installation Steps

Installing Communicator in Panel

Installing the Communicator with HS20 XX Panels

Detailed steps for mounting the communicator within HS20XX series panels.

Communicator Placement and Signal Testing

Cellular Communicator Placement Test

Procedure for placement testing cellular communicator models for optimal radio operation.

Panel and Communicator Initial Programming

SMS Command and Control

Communicator LED Status Details

Yellow Trouble LED

Interpretation of the yellow trouble LED flashes indicating specific troubles.

Communicator Reset and Firmware Update

Factory Defaults Reset

Procedure to reset communicator programming to factory defaults using a jumper.

Firmware Update

Information on updating communicator firmware via cellular or Ethernet.

Communicator Troubleshooting

Trouble Indications and Solutions

Table mapping trouble indications, causes, and possible solutions for troubleshooting.

EthernetCellular Programming Options

System Options

Configuration settings for Ethernet IP, subnet mask, gateway, and supervision intervals.

System Test Options

Configuring primary/secondary receiver test transmissions and alternate test options.

Command and Control Options

Toggles for SMS notification, command/control, and SMS retry attempts.

Receiver Diagnostic Testing

Diagnostic Test Transmission

Forcing immediate test transmissions to specific receivers for path verification.

Communicator Status and Response Codes

Response Code Descriptions

Table mapping response codes to actions for firmware updates and panel status.

Communicator Status Details

Radio Signal Strength Indicators

Interpretation of signal strength digits and levels for cellular radio.

System Reset Defaults

Software Default Options

Options for resetting module to factory defaults or performing a soft reset.

EthernetCellular Programming Worksheets

Command and Control Options Worksheets

Worksheets for SMS notification, command/control, and SMS retry attempts.

Related product manuals