EasyManuals Logo

DSC T-LINK TL250 User Manual

DSC T-LINK TL250
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
4
2.3 Resetting to Factory Defaults
Hardware Defaults (all modes)
Remove Power from the T-Link TL250/TL300; disconnect battery and control panel if
applicable
Disconnect all wiring from the PGM1 and IN1 terminals. Connect a jumper wire between
the PGM1 and IN1 terminals
Apply power to the system
Remove power from the T-LINK TL250/TL300 for approximately 20 seconds
Reconnect all original wiring and reapply power to the T-Link TL250/TL300.
Test System - refer to section 2.2
NOTE: A restart is required for the programming changes to take effect. Allow up to 15 sec-
onds for a restart.
Mode 4:
In mode 4, the T-Link can be Defaulted through the panel keypad:
Enter section 999 of the T-Link TL250
Enter 00 to default the unit to factory settings
Enter 55 to restart the unit.
2.4 LCD 5500 Programming
All Modes (Software version 1.2 only)
Local programming of basic options can be done through a standard DSC Power LCD keypad.
Connect the keypad on the T-Link Keybus terminals. Access to programming mode uses the
same code as the console (default is '5555').
NOTE:Programming mode access can be done only on power up for 30 seconds, and only
if the reset to factory default is not activated.
Access the Installer mode using [*][8], followed by the installer code.
NOTE:The [*] and [#] keys are not supported to re-enter installer code in the event of an
incorrect entry. All keys will be ignored if the correct sequence following [*][8] is not
entered.
Four Programming Sections are available and will be displayed in the sequence indicated
below. See section 9 for details
[001] T-Link IP Address:
|___|___|___|.|___|___|___|.|___|___|___|.|___|___|___|
[003] T-Link Account Code
|___|___|___|___|___|___|___|___|___|___|
[007] Primary Receiver IP Address
|___|___|___|.|___|___|___|.|___|___|___|.|___|___|___|
[007] Primary Receiver Gateway IP Address
|___|___|___|.|___|___|___|.|___|___|___|.|___|___|___|
When programming is completed, press the "#" key to save changes and exit programming
mode. A 2-minute timing delay begins when entering the programming mode. At the end of the
timing delay T-Link will exit program mode and save the changes made regardless of where
the programmer is in the programming sequence.
Remove power from the system
Reconnect all original wiring and reapply power to the system
Test System - Refer to section 2.2
NOTE: A restart is required for the programming changes to take effect. Allow up to 15 sec-
onds for a restart.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DSC T-LINK TL250 and is the answer not in the manual?

DSC T-LINK TL250 Specifications

General IconGeneral
BrandDSC
ModelT-LINK TL250
CategoryCell Phone
LanguageEnglish

Related product manuals