18
Section 10: Programming Descriptions (Advanced)
[001] Module IP (Static IP address for the T-Link module)
Default: 192.168.000.099
Unique IP address for the module. The network administrator will provide this information. To
enable DHCP program the address as 000.000.000.000.
[002] Subnet Mask
Default: 255.255.0.0
Must equal the subnet mask for the local subnet. For any single subnet, there is only one valid
subnet mask; all nodes on the same subnet will use the same subnet mask. The network admin-
istrator will provide this information.
NOTE: If DHCP is enabled then this section will be ignored.
[003] T-Link Account Code
Default: 0000FFFFFF
The account number is used by the central station to distinguish between transmitters. There
is one account number programmable for the T-Link. This account number is only used
when transmitting signals from inputs or internal troubles. Signals received on the PC-Link
will use the panel's account number.
NOTE: Account codes 0000FFFFFF, FFFFFFFFFF and 0000000000 are not valid accounts.
Refer to section 5.3 T-Link DVACS Programming.
[004]-[005] Encryption Password (32 Hex characters max.)
Default: None
Once programmed the T-Link will use this data to encrypt and decrypt all receiver and DLS
messages. The user can program a value from 1-8 bytes long in each section. To disable the
encryption, program both sections with zeros. If the encryption key does not match the cen-
tral station key, then the communication will FTC.
NOTE: For UL/ULC Installations, an encryption key is required.
NOTE: E-mail messages are not encrypted.
[006] T-Link Installer Code
This code (default 5555) is required when using the T-Link Console to remotely or locally
program the T-Link.
[007] Receiver #1 IP (Static IP address for the receiver)
Default: 000 000 000 000
Program the IP address of the central station receiver.
[008] T-Link Gateway
Default: 000.000.000.000
This is the IP address of the local gateway the T-Link can use to connect with the receiver
(WAN network).
The IP address of the gateway must also be a valid IP address for the local subnet.
NOTE: If DHCP is enabled then this section will be ignored.
[009] Receiver #1 T-Link Source Port Number
Default: 3060
[010] Receiver #1 T-Link Destination Port Number
Default: 3061
[011] Receiver #2 IP (Static IP address for the second receiver)
Default: 000.000.000.000
Program the IP address of the second receiver.
To Next Page
Loading...
