DSC WP8010 User Manual

MENUS AND FUNCTIONS
D-306232 WP8010/WP8030 V18 DSC EN USER 45
B.15 Volume Control
The system allows you to adjust the volume level of the various system beeps, chime signal and voice prompts,
and to enable or disable status dependent, pre-recorded verbal messages (Voice option) that are heard over
the built-in loudspeaker.
Here you can enable / disable the Voice option and change the volume level of the following:
 Keypad beeps
 Chime signal
 Exit/Entry beeps
 Confirmation beeps
 Trouble beeps
 Voice commands

Carefully read the section titled "Additional Information" according to the indicated references
1
etc – see
table at end of this section.
A. To Adjust the Volume Level of the Keypad Beeps
1.
VOLUME CONTROL
Enter the [USER SETTINGS] menu, select the [VOLUME CONTROL]
option and press .
1
2.
KP beeps vol.
The display will read [KP beeps vol.]. To enter this option press .
MID 
The display shows the currently selected option.
2
3.
or
Click the or button until the display reads the desired
volume level for the keypad beeps, for example, [MAX].
3
MAX
4.
When you are satisfied with the setting, press to confirm.
6
MAX 
A "Happy Tune" ☺ sounds. The display confirms the saved setting, then
returns to step 2.
4, 7, 8
☺ Return to step 2
B. To Adjust the Volume Level of the Chime Signal
5.
or
Click the or button until the display reads [Chime signal
vol], and press .
6.
Chime signal vol
MID 
The display shows the currently selected option.
2
7.
or
Click the or button until the display reads the desired
volume level for the chime signal, for example, [MAX].
3
MAX
8.
When you are satisfied with the setting, press to confirm.
6
MAX 
A "Happy Tune" ☺ sounds. The display confirms the saved setting, then
returns to step 6.
4, 8
☺ Return to step 6

DSC WP8010 Specifications

General

Brand	DSC
Model	WP8010
Category	Control Panel
Language	English