ENGLISH
6
7
ENGLISH
Buon Management
Where supported by soware, many of the hard buons on the DT390/ DT390c are
programmable to perform a funcon of the user
’
s choice. The excepon is the Power
Buon and the SAS Buon. To acvate the buon re-assignment applicaon, invoke the
Buon Manager applicaon, e.g., in Windows XP Embedded
.
Brightness Control
Where supported by device firmware and soware, a hard buon may be engaged to
manipulate the display brightness. Press the System Menu buon (Buon 7) on the front
of the DT390/ DT390c. The System screen will display a Brightness control secon with
up and down arrows that can be acvated with the stylus.
Baery and Power Management
The DT390/ DT390c is equipped with an internal 3760mAh Li-Ion baery pack that is
capable of supporng approximately 3 - 4 hours of connuous operaon. With the
internal baery and an external baery pack that clips (hot-pluggable) onto the back
of the device, the maximum period of connuous operaon will be approximately 6 - 8
hours. The period between baery recharges can be significantly lengthened by pung
the device into Standby mode thro
ugh the Power Buon (see Buons Funcon Table)
whenever the device is not in use. Depending on the operang soware, the DT390/
DT390c may also be configured to enter various power-saving modes via the Power
Buon or through med entry.
Desktop Cradle
The DT390/ DT390c is complemented by an oponal Desktop Cradle for support, pass-
through charging, and connecon to a range of USB peripherals, includi
ng keyboard and
mouse. The Cradle offers the following interfaces: a DC-in port for the AC-DC adapter, an
Ethernet port, and USB ports. Always seat the DT390/ DT390c securely onto the cradle.
The cradle must be powered by the AC-DC adapter for the Ethernet and USB ports to
funcon. The baery packs on the DT390/ DT390c may be recharged by connecng the
AC-DC adapter directly to the DC-in port on th
e DT390/ DT390c or through the DC-in
port on the Desktop Cradle while the DT390/ DT390c is docked to the Cradle.
USING THE DT390/ DT390c
Memory & Storage configuraon
The DT390/ DT390c is available with 2GB memory configuraon. Storage opons
currently range from: 2GB to 32GB flash memory or 32GB to 64GB SSD.
Peripherals Support
Through its USB ports, the DT390/ DT390c supports a wide range of USB-based
peripherals. These peripherals are applicable for soware installaon, applicaons
storage, data storage, and system soware recovery and updates. The DT390/ DT390c is
also compable with custom mountable cradle opons. These securable and mountable
cradles provide an interface to VESA mounts and arms, and to ports that may include
USB, Ethernet and pass-through power.