3
FEATURES:
Standard mode.
Selectable motor direction change.
Auto close facility. (Infra-red beams must be fitted if auto close is activated).
Party mode. (Auto close override)
Condominium / Free exit loop facility.
P.I.R.A.C. (Passive Infra-Red Access Control) facility.
Slowdown (Ramp down) facility.
Tamper facility, Anti-hijack/Alarm facility.
On board Receiver.
BASE PLATE MOUNTING INSTRUCTIONS
1. Assemble base plate by fastening M10x30 Hex set screws into base plate from under
the base plate up and tightening into position.
2. Mount base plate with bolts 160mm from the centre of the gate track and centre of base plate a
minimum of 250mm away from the gate opening.
3. Secure the base plate to the gate track by welding the base plate directly to the gate track.
(Ensuring a distance of 160mm from centre of gate track to centre of fastening screws).
4. Fit all required cabling through hole provided in base plate.
5. Support the back of the base plate with 40x40x3 angle iron (not provided) or similar off cut steel
knocked approximately 300 to 400mm into the ground.
6. Fill area below and around the base plate with approximately 300x400x300 concrete to ensure
that the motor will be secured.
7. NOTE – For SAFETY reasons, ALL motors should be fitted with a set of IR beams.
To Next Page
Loading...
Need help?
General
